Recess Mounted Hand Dryer shall operate automatically from IR sensor that shall activate dryer when hands are placed in sensor zone. Cover and hand drying chamber shall be 18 gauge type 304 stainless steel alloy 18-8. All exposed surfaces shall have satin finish and shall be protected during shipment by PVC film easily removable after installation. Cabinet shall be 20 gauge corrosion protected steel with a 1/2" (13) wide perimeter trim to lay flush against wall and shall have flush pin- hex security screws to close cover. Motor and heating element shall have internal resetting automatic thermal protection. Fixed directional air vanes shall be heavy duty, rust proof and tamper resistant. Air intake slots shall not allow access to internal parts. Circuitry shall have self-adjusting time-out and fail-safe off protection controlled by a microprocessor that shall detect and reject false signals and shall automatically self calibrate to provide uniform sensitivity over its entire life span. Entire unit shall be internally electrically grounded. Dryer unit shall have approval and be listed under the re-examination services of Underwriters Laboratories, Inc. Owner’s Manual (OM) and Mounting Template are supplied with unit. Electrical Specifications: Motor: 1/4 HP - 7500 RPM - Brush Type. Voltage: 100-240 – 50/60 Hz. Air Output: 186 CFM max (314.5 m3 /h) - Temp: 149° F (65°) @ 77° F (25°)ambient room temp. Heater: 1857 Watts. Current: 17.6 Amps @ 115 VAC; 18.3 Amps @ 240 VAC.